The right humidity in the tent depends on temperature and phase: at an air temperature of 24 °C, the guide values are roughly 62 to 75 per cent for cuttings, 48 to 62 per cent in vegetative growth and 38 to 55 per cent in flowering. Behind this is the VPD, which combines temperature and humidity into one value. You humidify with an ultrasonic humidifier, and you dehumidify mainly via the exhaust air and, if the room air is humid, with a dehumidifier. You measure at plant height, not on the tent floor, and at night just as attentively as during the day.
Which humidity is right in the tent, and what is VPD?
Relative humidity tells you what percentage of the maximum possible amount of water vapour the air currently contains. Because warm air can hold more water, 60 per cent at 26 °C means something different than at 20 °C. The VPD (vapour pressure deficit) solves this problem: it states in kilopascals (kPa) how strongly the air draws water from the leaves. A low VPD means humid and sluggish, a high VPD means dry with strong evaporation.
| Phase | VPD guide value | Humidity at 24 °C | Humidity at 26 °C |
|---|---|---|---|
| Cuttings and seedlings | 0.4–0.8 kPa | 62–75 % | 65–77 % |
| Vegetative growth | 0.8–1.2 kPa | 48–62 % | 53–65 % |
| Early flowering | 1.0–1.4 kPa | 42–55 % | 47–59 % |
| Late flowering | 1.2–1.5 kPa | 38–48 % | 44–53 % |
The values come from Hanf-Magazin and apply to the light phase, calculated with a leaf temperature 2 °C below the air temperature. The sources differ slightly: Norddampf gives 1.2 to 1.6 kPa for late flowering, while the dehumidifier manufacturer Quest sees about 0.8 kPa as a general target and 0.4 to 1.25 kPa as the tolerated range. They all agree: young plants like it more humid, and it gets drier towards late flowering. According to Norddampf, you should change the VPD by no more than 0.3 kPa per day.
How do I get more humidity into the tent?
In growing, ultrasonic humidifiers are common. A vibrating membrane atomises water into a cool mist without heating it. According to the US Environmental Protection Agency (EPA), however, ultrasonic devices also disperse the minerals from tap water as white dust; it recommends distilled water. Evaporative humidifiers blow air through a damp wick and release hardly any minerals, while steam humidifiers heat the water and also bring extra heat into the tent.
- Compact unit with tank: According to the product data, the Taifun Fog Box V has a 4.5-litre tank, is adjustable up to 250 ml per hour, uses 30 watts and switches off when the tank is empty.
- Fogger for your own container: The Taifun Fog Machine I floats in the water container with a float ring and mists 2 to 5 cm below the surface. According to the product data, it manages over 500 ml per hour at 20 watts, with a water temperature of 5 to 50 °C.
Do not point the mist directly at leaves or the lamp. The EPA advises emptying the water container regularly and cleaning it about every third day, because germs and limescale collect in standing water.
How do I lower the humidity?
Plants constantly release water through their leaves, which is why the tent tends to be too humid rather than too dry. The most important control is the exhaust air: it exchanges humid tent air for room air. However, this only works if the room air is drier. How powerful the fan needs to be is explained in our guide Sizing your exhaust.
- Turn up the exhaust: More air exchange lowers the humidity fastest, as long as the room is drier.
- Switch on air circulation: A fan prevents humid pockets between densely packed leaves.
- Avoid wet surfaces: Open water containers, run-off water in saucers and wet floors also evaporate.
- Dehumidifier in the room: If the room air is already humid, for example in a cellar or in summer, the only thing that helps is a dehumidifier that dries the intake air. Dehumidifiers are currently not in the online shop, so ask in the shop.
A climate controller takes the readjusting off your hands. According to the product data, the GrowControl GrowBase controls temperature, humidity, CO2 and negative pressure, drives EC and AC fans and switches humidifiers or dehumidifiers via freely assignable sockets. Most values can be set separately for day and night. The GrowBase Lite offers this with two sockets instead of four. Simpler is the 150 mm complete exhaust set, whose controller adjusts the fan output to target values for temperature and humidity.
Where do I hang the hygrometer?
According to Hanf-Magazin, the sensor belongs at canopy height, in the centre and slightly offset. On the tent floor or the tent wall the air is cooler and more humid, under the lamp it measures radiant heat, and at the intake duct it measures the room air.
- Simple: According to the manufacturer, the Garden Highpro Hygrothermo Basic measures 25 to 90 per cent humidity with ±5 per cent accuracy and stores minimum and maximum values.
- With a second temperature probe: The Hygrothermo with 2 measuring points also has an external temperature probe. The humidity sensor sits in the unit, so hang the unit itself at plant height.
- Leaf temperature: The GrowControl IRCube measures leaf temperature by infrared, accurate to ±0.3 °C according to the manufacturer. This is useful for precise VPD control, because many controllers otherwise calculate with the air temperature.
±5 per cent sounds like little, but with a reading of 60 per cent it shifts the real value to anywhere from 55 to 65 per cent. You can check this with the salt test: place damp, undissolved table salt in a small dish together with the hygrometer in an airtight container and wait about 24 hours. The air inside settles at 75 per cent; note the deviation and factor it out in future.
Why does humidity rise at night, and what helps?
When the light goes out, the air cools down. The amount of water stays the same, but cool air can hold less, so the relative humidity rises. Quest works it out: air at 57 per cent at around 24 °C ends up at about 80 per cent at around 18 °C without dehumidification. In the morning this reverses, and the humidity drops noticeably as the tent warms up.
According to Hanf-Magazin, a slightly lower night-time VPD is normal. It becomes critical in late flowering, when the humidity rises so far at night that mould gets a chance. Quest names still air above 55 per cent at 10 to 21 °C as favourable conditions for grey mould (botrytis). The remedy: do not switch off the exhaust at night, but control it via separate night values on the controller, keep the air circulation running, keep the temperature drop small and read the hygrometer’s min/max values in the morning.
Common mistakes: what often goes wrong with humidity in the tent?
- Judging humidity without temperature: 60 per cent at 20 °C and at 28 °C are two different climates. Always look at both together.
- Hygrometer on the tent floor: It is cooler and more humid there, so the reading does not match leaf level.
- Tap water in the ultrasonic unit: White mineral dust settles on leaves, lamp and equipment. Use distilled water.
- Humidifier and exhaust working against each other: If both run at full power at the same time, you use water and electricity for nothing. Separate the target values cleanly in the controller.
- Exhaust off at night: Without air exchange, humidity rises quickly after lights-out.
- Big jumps: Change values step by step and give the climate 30 to 60 minutes before you readjust.
- Never calibrated: A hygrometer with ±5 per cent can lead you to adjust in the wrong direction. Do the salt test once and note the deviation.
In our shop at Lorenzstraße 9 in Hof, we help you put together humidifiers, hygrometers and controllers to suit your tent size and room. Online you will find everything under Humidifiers, Measuring equipment and Climate control.