Fertilisers & substrates 6 min read

Fertiliser basics: NPK, growth, bloom and supplements

What the NPK numbers on the bottle mean, when to give grow and when to give bloom fertiliser, and how mineral and organic fertilisers differ. With tables, starter sets and instructions for careful dosing according to the manufacturer’s schedule.

Plants mainly need the three primary nutrients nitrogen (N), phosphorus (P) and potassium (K), plus calcium, magnesium, sulphur and small amounts of trace elements. The three numbers on the bottle are the NPK value in per cent, always in this order. In the growth phase you give a grow fertiliser with more nitrogen, and from flowering onwards a bloom fertiliser with more phosphorus and potassium. You dose according to the manufacturer’s schedule, and preferably too weak rather than too strong: too little fertiliser can be made up for in a few days, too much takes considerably longer to put right.

Which nutrients does a plant need?

The plant takes up macronutrients in larger amounts and trace elements only in very small ones. The Royal Horticultural Society (RHS) classifies the main nutrients as follows:

NutrientGroupWhat the plant needs it for
Nitrogen (N)primary nutrientleaf and shoot growth
Phosphorus (P)primary nutrientroot and shoot development
Potassium (K)primary nutrientflower and fruit formation, cold hardiness
Calcium (Ca), magnesium (Mg), sulphur (S)secondary nutrientsoften contained in fertiliser; calcium and magnesium are an issue with coco and soft water
Iron, manganese, zinc, copper, boron, molybdenumtrace elementsonly needed in very small amounts; usually present in soil, supplied via the fertiliser with coco and hydro

A CalMag supplement such as BioBizz CalMag or Hesi CalMag is mainly useful with very soft water, reverse osmosis water and coco. Why coco binds calcium and magnesium is explained in the guide Soil, coco or hydro.

How do I read the NPK value on the label?

The three numbers always stand for nitrogen, phosphorus and potassium, in this order and as a percentage. NPK 3-3-4 therefore means 3% nitrogen, 3% phosphorus and 4% potassium. The numbers describe a ratio and the concentration in the bottle, not the amount you add to your watering water. That always comes from the manufacturer’s schedule.

One pitfall: in the EU, phosphorus and potassium are usually stated as oxides, i.e. as P₂O₅ and K₂O. The proportion of the pure element is smaller. The RHS gives the example of a label with 7% potassium oxide, which corresponds to 5.8% pure potassium. That is why some labels show two figures for the same nutrient. Examples from the shop: according to Plagron, Plagron Terra Grow has NPK 3-1-3, Terra Bloom 2-2-4, Hesi Blüh-Complex 3-3-4 and the organic BioBizz Grow·Soldier 5-2-3. With Hesi PK 13/14, the phosphorus and potassium contents are already in the name.

What is the difference between grow and bloom fertiliser?

In the growth phase, the plant builds leaves and shoots and needs a lot of nitrogen. From flowering onwards, the need for nitrogen falls, and phosphorus and above all potassium become more important. Hanf-Magazin gives rough ratios of about 3-1-4 in the growth phase and 1-1-2 in flowering; Nordleaf describes the same principle. The switch does not have to happen overnight; Hanf-Magazin recommends spreading it over two to three feeds.

Typical pairs are BioBizz Bio·Grow and Bio·Bloom or Plagron Terra Grow and Terra Bloom. From Canna, we currently stock online the organic grow fertiliser Bio Vega for soil and Aqua Vega for recirculating hydro systems; the matching bloom fertilisers are not currently in the online shop, so ask about them in our shop.

Mineral or organic: which suits me?

FeatureMineralOrganic
Availabilitycan be taken up immediatelyfirst has to be broken down by soil life
Concentrationusually higherusually lower
Margin for erroroverdosing hits the roots quicklymore forgiving, works more slowly
Controlprecisely via the EC valueEC value less meaningful
Substratesoil, coco, hydromainly living soil, sometimes coco
Mixed solutionPlagron: use within 4 daysCanna Bio Vega: use within 24 hours

This classification follows the RHS: organic fertilisers are generally less concentrated and work more slowly, mineral ones are stronger and faster. Plagron advises against putting organic products in the same tank as a mineral solution, because they spoil quickly.

All-in-one fertiliser, components or starter set?

All-in-one fertilisers cover the whole cycle with one bottle, for example 420Flow organic fertiliser or BioBizz Grow·Soldier. That is simple, but leaves you little room for adjustment. Component fertilisers separate growth, bloom and supplements. Hydro fertilisers such as Canna Aqua Vega are additionally split into A and B, because some ingredients are not compatible in one bottle; here you always add A to the water first, stir, and then add B. Supplements such as root stimulators, bloom boosters or PK 13/14 are only added as extras, never instead of the base fertiliser.

To start with, a starter set is practical, because the base fertilisers and supplements are matched to each other and a schedule is included:

How do I dose correctly?

Stick to the manufacturer’s feeding schedule and treat the figures as an upper limit, not a target. BioBizz writes in its nutrient schedule that it is always better to be sparing than to add more: a plant can cope with too little fertiliser, but not with an overdose. Plagron states a maximum of 5 ml per litre for Terra Grow, i.e. 1:200.

  1. Read the schedule: Does it suit your substrate? BioBizz has a separate, weaker schedule for pre-fertilised soil such as All·Mix than for Light·Mix or coco.
  2. Start weak: Hanf-Magazin advises starting with half the manufacturer’s dose if in doubt and increasing it over several feeds.
  3. Mix properly: Shake the fertiliser before use, measure it with a measuring cup or syringe, and stir in A and B separately one after the other.
  4. Check pH and EC: Add the fertiliser first, then adjust the pH. How to do this is explained in the guide Measuring pH and EC.
  5. Watch the plant: According to Hanf-Magazin, burnt leaf tips that claw downwards and very dark foliage indicate too much fertiliser. In that case, reduce the next feed.

Do I need to flush before harvest?

The advice differs here, so the rule is: flush only as the manufacturer of your fertiliser specifies. The BioBizz nutrient schedule shows only plain water in the week before harvest. For its product Canna Flush, Canna recommends watering with it once a week one to two weeks before harvest; in between, according to Canna, you continue feeding according to the normal schedule. Hanf-Magazin gives 10 to 14 days with no fertiliser at all. Canna Flush is not currently in the online shop, so ask about it in our shop.

Common mistakes: what often goes wrong when feeding?

  • Full dose from day one: Young plants and freshly repotted ones need little. Start with a weak dose and increase it.
  • Pre-fertilised soil fed on top: All·Mix and similar soils provide for the first few weeks themselves. Use the matching, weaker schedule.
  • Fertiliser does not match the substrate: Soil fertiliser in hydro or aqua fertiliser in soil leads to deficiencies. Check the label.
  • A and B together in the cup: The ingredients react with each other and precipitate. Always add them to the water one after the other.
  • Too many supplements at once: Every booster increases the salt load. Get confident with the base fertiliser first.

In our shop at Lorenzstraße 9 in Hof, we will show you the feeding schedules from BioBizz, Hesi and Plagron and put together a set to suit your substrate with you. Online you will find everything under Fertilisers and Fertiliser starter sets.

Featured in this guide

Frequently asked questions

Why does my bloom fertiliser still contain nitrogen?

The plant needs nitrogen in the flowering phase too, just less than during growth. Bloom fertilisers therefore shift the ratio in favour of phosphorus and potassium instead of leaving out nitrogen entirely. Pure PK supplements such as PK 13/14 complement the base fertiliser and do not replace it.

Can I mix fertilisers from different brands?

It is possible, but the manufacturers’ schedules are tailored to their own products. If you mix, you lose this coordination and have to monitor pH and EC more closely. Especially at the beginning, it is simpler to stick to one range.

How long does mixed fertiliser solution keep?

Organic solutions spoil quickly; for Canna Bio Vega, the product information states 24 hours. For mineral solutions, Plagron gives up to four days for Terra Grow. The safest approach is to mix only as much as you need for watering.

Do I really need boosters and supplements?

No, the basic supply comes from grow and bloom fertiliser. Supplements such as root stimulators or bloom boosters are extras that you can try out selectively later on. Every supplement increases the amount of nutrients in the water, though, so do not start everything at once.

How can I tell that I have overfed?

Typical signs are burnt leaf tips that curl downwards, conspicuously dark green foliage and stunted growth. With coco and soil, it helps to check the EC value of the run-off water: if it is well above that of the fertiliser solution, reduce the next feed.

Sources

All information to the best of our knowledge and based on manufacturer data as of the date shown. It does not replace the manufacturer’s instructions. This guide was created with AI assistance and reviewed by our team.

More from Fertilisers & substrates