Harvesting & storage 4 min read

Drying correctly: temperature, humidity and duration

Slow, dark and cool: the values at which herbs and flowers dry evenly, whether a drying net or hanging is better and how to tell when everything is done.

Herbs and flowers dry best slowly, in the dark and cool: at around 15 to 20 °C and 45 to 55% humidity, with gentle air movement in the room but no fan blowing directly at them. Hanging usually takes 7 to 14 days, lying in a drying net often 5 to 10 days. It is done when thin stems snap audibly when bent instead of just bending.

Why dry slowly and not fast?

During drying, the water should escape evenly from the inside out. If it is too warm or too dry, the surface dries faster than the inside: the outside becomes brittle while moisture stays trapped inside. That harms aroma and shelf life and can later lead to mould in the jar. If it is too cool and humid, on the other hand, drying takes so long that mould can already form in the drying room.

That is why a little effort pays off: a dark room or a blacked-out tent, a hygrometer and gentle air movement.

What climate do I need for drying?

The goal is constant values without big jumps between day and night. Light, especially direct sunlight, does not belong in the drying room.

ValueGuide valueWatch out for
Temperature15 to 20 °C (some sources say up to 21 °C)Do not hang next to a heater, lamp or window
Humidity45 to 55%Above 60% the risk of mould rises, below 40% it dries too fast
LightdarkLight bleaches colour and aroma
Air movementgentle, in the roomNever point a fan directly at the drying material
Durationhanging 7 to 14 days, lying 5 to 10 daysDepends on density, size and room climate

You can check the values with a simple digital thermometer/hygrometer. A small clip fan blowing against the wall or upwards keeps the air moving without blowing directly on the drying material.

Hanging or drying net – which is better?

Both work; what matters is the space available and how dense the material is. Hanging on a line or hanger, whole branches dry evenly because air reaches them from all sides. In a drying net, smaller pieces lie individually on several tiers, which saves space and is faster but needs a little more attention.

  • Drying net: Lay the pieces individually and with space between them, do not stack them. Turn them once or twice a day so that no pressure spots form. Our nets range from compact to large, for example the Dry-it-45 (stackable), the HNBG net with 60 cm and 6 tiers or the PRODRY BASIC 90 with 8 tiers.
  • Hanging: Hang branches with space between them so that they do not touch. Dry large, dense pieces preferably hanging.
  • Trim beforehand: Remove large leaves with fine harvest scissors; this speeds up drying and reduces pockets of moisture.

How do I know it is fully dried?

The simplest check is the stem test: bend a thin stem. If it only bends, there is still too much moisture inside. If it breaks with an audible snap, it is done. If it breaks silently and crumbles, it is already too dry.

The material should feel dry on the outside but not bone-dry inside. For the subsequent curing in the jar, a residual humidity of about 60 to 65% is considered a good starting point. How to store it properly afterwards is explained in the guide Storing without mould.

What if it dries too fast or too slowly?

If it is already brittle after a few days, it is too warm, too dry or the draught is too strong. Lower the temperature, reduce the air movement or hang larger branches instead of small pieces. If it is still soft after two weeks, it is too cool or too humid: lower the humidity, increase the air movement in the room and leave more space between the pieces.

If it has accidentally become too dry, a humidity pack such as Boveda 62% in a closed jar helps to raise the humidity slowly again. Which level suits which purpose is explained in the guide Boveda 58 or 62.

Common mistakes: what often goes wrong when drying?

  • Dried too warm: A heater, lamp or a spot under the roof makes the surface dry too fast.
  • Fan pointed directly at it: This dries unevenly and too fast. Only move the air in the room.
  • Laid or hung too densely: Where pieces touch, moisture lingers and mould can develop.
  • Dried in the light: Light bleaches colour and aroma.
  • Jarred too early: If the stem still bends, it is too moist for the jar.
  • Not measured: Without a hygrometer, you notice too late that the air is too humid or too dry.

In our shop at Lorenzstraße 9 in Hof, we can show you drying nets in different sizes and advise you on which one suits your space. You will find everything for drying online under Cutting & drying and measuring devices under Measuring technology.

Featured in this guide

Frequently asked questions

Can I dry faster with a heater or hair dryer?

No. Heat only dries the surface quickly while moisture stays trapped inside. That harms aroma and shelf life and can later lead to mould in the jar. It is better to dry slowly at 15 to 20 °C.

How often do I need to turn the material in the drying net?

Once or twice a day is enough. That way the pieces dry evenly and do not get flat pressure spots. It is important that they lie individually and with space between them.

What humidity is too high when drying?

If the humidity stays above about 60% for a longer time, the risk of mould rises considerably. The target is 45 to 55%. Measure with a hygrometer and move the air in the room when the values rise.

Can a fan run in the drying room?

Yes, but only to move the air in the room. Point it at a wall or upwards, never directly at the drying material. A direct draught dries unevenly and too fast.

What do I do if everything has become too dry?

Put the material in an airtight jar and add a 62% humidity pack. After about one to two days the humidity will have levelled out. Re-moistening with water or fruit peel is not a good idea, as it encourages mould.

Sources

All information to the best of our knowledge and based on manufacturer data as of the date shown. It does not replace the manufacturer’s instructions. This guide was created with AI assistance and reviewed by our team.

More from Harvesting & storage